Industrial filter cloth must be in a sealed place, isolated from the air to prevent moisture absorption. Isocyanate and combination of polyether barrels should not be exposed to sunlight, must be away from heat, place a cool dry place, the barrel if the upright placed, the lid may not be water. If the whole barrel can not be used up once, it must be immediately after each use to cover the lid, to prevent water vapor, impurities into the barrel and affect the quality. If you use more than two grades combined polyether, should be branded, and there are obvious signs. Add ordinary flame retardant combination of polyether storage time should not be too long, must be the same day the day of preparation, or easy to cause deterioration of the quality of foam.
Industrial filter cloth measurement techniques: first ready to measure the filter cloth materials and tools, soft braided rope, tape measure. And then let the belt filter press normal operation, the motor speed to a minimum speed. When a metal fitting is run to the filter press, a sufficiently long knitting rope is attached to the metal tab of the filter cloth. Let the braided rope with the filter cloth running rotation.
Then, when the knitting rope rotates with the tape for one week, that is, when the metal joint is present, the knitting rope is marked. This is to measure the length of the weaving rope around the filter cloth, that is, the length of the filter cloth. Finally, the same method measures the length of the other filter. When measuring the time to pay attention to the braided rope in the operation of the filter cloth, holding a knitting rope at the end of the filter cloth running a little bit of force, so that braided rope taut, or measured the length of the error is relatively large, Ignore the length of the metal connector, the metal connector to be measured in the length of the filter.
浙江天台丰顿滤料有限公司是一家专业从事：液体过滤袋、工业滤布、滤布、滤袋、除尘袋生产销售的滤布厂家，多年来在液体过滤袋、滤袋、工业滤布、除尘袋生产上积累了丰富的经验和领先的技术。
|
