The breathable fabric temperature can reach 180°C instantaneously and 160°C or so at a constant temperature. Breathable cloth (breathable layer), made of high-quality heat-resistant, corrosion-resistant chemical synthetic fibers, and woven on specific equipment in accordance with specific requirements, its technical performance and product quality have reached the international advanced level of similar products. Breathable cloth has the advantages of high temperature resistance, corrosion resistance, wear resistance, low moisture absorption, light weight, smooth surface, long service life, etc. Breathable cloth is easy to maintain, good sealing, no noise, safe and reliable operation, low power consumption, It is convenient to change the conveying direction, and it can be widely used for multi-point feeding and multi-point discharge. The
Because the gas permeable layer is mainly used in industrial cement tanks and gas transportation pipelines, it brings convenience to industrial production. At the same time, breathable materials are also used in waterproof and breathable materials in life. Therefore, we must learn more about the application and characteristics of breathable layers. Knowledge, to ensure that the product is qualified, is the main purpose. The
How is the installation of the breathable layer in the chute vent plate? Here's to listen to us to introduce you:
1. Trim, cut the breathable layer according to the specified size, and block the incision with an electric iron (or a heated steel bar) to prevent it from dissipating;
2. Punch, use an iron bar that is slightly smaller than the diameter of the mounting bolt to heat, pierce the perforated area around the breathable layer. Be careful not to let the open flame burn the breathable layer when perforating. If drilling with a drilling rig, use a hot iron stick to block the hole during the hole to prevent it from dissipating.
3, the breathable layer tiled in the lower slot, through the bolt, surrounded by iron bars pressed, tighten the screw can be used;
4, the pressure (or flange) should be deburred, welded flat;
5, in order to ensure the seal, to be white latex around the bottom surface of the breathable layer.
The above is some knowledge of breathable fabrics for everyone. I hope to help you with your production.
(Addtime：2018-4-11)
